![]() The issue with this is that member tracks all include the aux busses and so we have to nudge the to right until we are only displaying member tracks. So basically, to have Master Aux Busses on the left hand side of the center console and member tracks on the right is easily possible in a few ways:ฤก - Custom Fader groups: this will allow all Master Busses to remain locked on the left hand side. is this possible? I intend to tinker around when I'm not busy mixing tomorrow. I rarely have more than 16 tracks in a given sub group, so this method would allow me to start at the sub group level, and then quickly focus in on any of the members of each group, always quickly on the right hand side for member tracks, and the left for their corresponding sub masters. If this was possible, and these subs were actually VCA faders, I believe then hitting VCA spill would allow their member groups to automatically show up spilled over the right hand side since that's all the space there would be for them. But would they be able to be LOCKED and kept un-bankable on the left hand side? Now I know I can create Custom Faders and make each of these 8 sub groups a custom fader. This workflow would be so quick and easy for me, and my way of thinking. I also wanted to be able to hit spill and have the member tracks that those subs represent spill over to the RIGHT hand 16 faders. However, they will move around a lot if I bank or nudge, and I'd ideally want them locked to that position. So ideally I'd like these physically located on the very left side of my D-Command so they show up as the 8 faders. The 8 stereo channels are usually something like | DRUMS | BASS | KEYS | VOCALS | BACKING VOCALS | GUITARS | PADS | EFX |. I sum with a Neve 5059 satellite and I usually create 8 summing groups which are essentially my sub busses that go out to my summing mixer. The way I'd ideally like to work, and the way I have my D-Command setup is with 8 faders on my left, the center section, and then 16 on my right. I'd like to start using it more (I guess I'm super slow to adopt features even with the board staring at me everyday). I've had a D-Command 24 fader setup for 15 years or so, but admittedly, I use it mainly for monitoring and automation. So on a D-Command I have a question about something I'd like to do but haven't really tried doing yet.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |